Renault Clio: Engine oil level: topping up, filling
Renault Clio IV (2014-2019) Owners Manual / Maintenance / Engine oil level: topping up, filling
Topping up/filling
The vehicle must be parked on level ground and the engine should be cold (for instance, before the engine is started up for the first time in the day).
| Before performing any action in the engine compartment, the ignition must be switched off by pressing the engine stop button (please see the information on “Starting, stopping the engine” in Section 2). |
- Unscrew cap 1;
- top up the level (as a guide, the capacity between the minimum and maximum reading on the dipstick 2 is between 1.5 and 2 litres, depending on the engine);
- wait for approximately 10 minutes to allow the oil to flow into the engine;
- check the level using the dipstick 2 (as described above).
Once the operation has been completed, ensure that the dipstick is pushed in as far as it will go and that the cap is completely screwed in.
| In order to prevent splashback, it is recommended that a funnel be used when topping up/filling with oil. |
| Do not exceed the max level and do not forget to refit cap 1 and dipstick 2. |
Oil change
Service interval: refer to the Maintenance Service Booklet for your vehicle.
Oil change capacity
Please refer to the maintenance document for your vehicle, or contact an authorised dealer.
Always check the engine oil level using the dipstick, as explained previously (it should never fall below the minimum level, or be over the maximum level on the dipstick).
READ NEXT:
Engine oil grade
Refer to the Maintenance Service
Booklet for your vehicle.
Filling: take care when
topping up the oil that
no oil drips onto engine
components - risk of fire.
Remember to refit th
Engine coolant
With the engine switched off and on
level ground, the level when cold must
be between the MINI and MAXI marks
on reservoir 1.
Top this level up when cold before it
reaches the MINI mark.
SEE MORE:
Petrol injection: List and location of components
D4F, and 740 or 742 or 764
Petrol vapour rebreathing solenoid
valve
Air inlet pressure sensor
Motorised throttle valve
Injection computer
(5) Fuel injection computer
(6) Motorised throttle valve
(7) Fuel vapour recirculation solenoid
valve
(8) Ignition coil
(9) Upstream oxygen sensor
(1
Oxygen sensors: Removal - Refitting
D4F, and 740
WARNING
Do not use any product designed to improve electrical
contact in the injection computer connectors
and oxygen sensors and on the oxygen sensor
body. Failure to respect this advice prevents the
oxygen sensor from operating correctly and results
in failure to comply with the emis
© 2016-2026 Copyright Renault Clio Owners Club - 0.0033
