Renault Clio: Access to towing points

Renault Clio. Access to towing points


Unclip cover 4 or 6 by sliding a flat tool (or the key integrated in the RENAULT card) under the cover.

Tighten towing hitch 3 fully: as much as possible by hand at first, then finish tightening it using the wheelbrace or, depending on the vehicle, the lever.

Only use the towing eye 3 and the wheelbrace located under the luggage compartment carpet in the tool kit (please refer to the information under “Tools” in Section 5).

  • Use a rigid towing bar.

    If a rope or cable is used (where the law allows this), the vehicle being towed must be able to brake.

  • A vehicle must not be towed if it is not fit to be driven.
  • Avoid accelerating or braking suddenly when towing, as this may result in damage being caused to the vehicle.
  • When towing a vehicle, it is advisable not to exceed 30 mph (50 km/h).
  • Do not push the vehicle if the steering column is locked.

Do not leave the tools unsecured inside the vehicle as they may come loose under braking.

READ NEXT:

 Operating faults

The following advice will enable you to carry out quick, temporary repairs. For safety reasons you should always contact an approved Dealer as soon as possible. Using the RENAULT card

 Technical specifications

The Renault Clio IV, produced from 2014 to 2019, offers a range of technical specifications that contribute to its performance and versatility. It is available with gasoline and diesel engine options,

 Vehicle identification plate

The information shown on the vehicle identification plate should be quoted on all correspondence or orders. The presence and location of the information depends on the vehicle. Vehic

SEE MORE:

 Pump - sender: Removal - Refitting

K9K, and 772 IMPORTANT During this operation, be sure to: beware of fuel splashes when disconnecting the union, protect sensitive areas from fuel outflow. IMPORTANT Wear gloves during this operation. IMPORTANT Wear goggles with side protectors for this operation. REMOVAL I - REMOVAL PREPARATIO

 Rear disc bearing: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Put the vehicle on a two-post lift (see Vehicle: Towing and lifting). Remove: the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1), the rear brake pads (see 33A, Rear axle components, Rear brake pads: Removal - Refitting,

© 2016-2025 Copyright Renault Clio Owners Club