Renault Clio: Cruise Control
Cruise control - speed limiter: List and location of components
CRUISE CONTROL
I - LIST OF COMPONENTS
- Switch
- Steering wheel switch
- Brake switch
- Clutch switch
II - LOCATION OF COMPONENTS
1 - Switch

2 - Steering wheel switch

3 - Brake switch

4 - Clutch switch

Switch: Removal - Refitting
CRUISE CONTROL

REMOVAL
I - REMOVAL PREPARATION OPERATION

- Unclip the switch panel (1) using the (Car. 1363).
- Disconnect the connectors.
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the switch by pressing on the clips (2).
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit the switch on the switch panel.
- Connect the connectors.
II - FINAL OPERATION.
- Clip the switch panel onto the lower cover.
READ NEXT:
Rotary switch: Removal - Refitting
The rotary switch is part of the steering column control
assembly. It cannot be replaced on its own.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the steering
Wiping and washing: List and location of components
Passenger compartment
fuse and relay box
Protection and Switching
Unit
Power supply fuse board
UCH
Rain sensor
Wiper switch
Windscreen wip
Radio: List and location of components
I - LIST OF COMPONENTS
The radio system comprises:
a radio control satellite (see 86A, Radio, Radio control
satellite: Removal - Refitting, 86A-19)
a radio a
SEE MORE:
K9K, and JA5
REMOVAL
I - REMOVAL PREPARATION OPERATION
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, run command
" Discharge pressure accumulator " AC081.
To confirm the pressure drop, read the " Hydr
K9K
WARNING
Always check the oil level using the dipstick.
Do not exceed the maximum level on the dipstick
(could destroy the engine).
Correct the engine oil level if necessary before
delivering the vehicle to the customer.
Note:
When topping up the engine oil, always leave at
least 10 minutes be
© 2016-2025 Copyright Renault Clio Owners Club
