Renault Clio: Tyre pressure: Identification
Renault Clio III (2005-2013) Service Manual / Chassis / Wheels And Tyres / Tyre pressure: Identification
I - INFLATION
WARNING
If checking the tyre pressure when hot, increase the recommended pressure by 0.2 to 0.3 bar.
B85 or C85 or S85
The pressure values given are recommendations when cold.
K85
II - CONFORMITY CHECK AND ADJUSTMENT
If the tyre size is changed, calibrate the electric power-assisted steering computer using the Diagnostic tool (see MR 394 Fault finding, 36B, Electric power-assisted steering, Replacement of components).
Wheel rim offset:
- steel wheel rim: 43 mm,
- alloy wheel rims: 50 mm.
For information on fitting chains, see " Driver's handbook ".
Tyres: Identification
Example of a tyre identification mark: 205/65 R 15 91 V.
Speed code table:
READ NEXT:
Wheel rim: Identification
IDENTIFICATION
1 - Marking
There are two types of identification marking on the
wheel rims:
engraved marking for steel wheel rims,
cast marking for alloy wheel rims.
The marking gives the main dim
Tyre Pressure Monitor
Tyre pressure monitor: List and location of components
TYRE PRESSURE SENSOR
The system consists of:
four pressure sensors (1) built into the valves (one per
wheel); the sensors transmit a radio si
SEE MORE:
Front seat height adjustment: Removal - Refitting
FRONT SEAT TYPE 02 or FRONT SEAT TYPE 03 or FRONT SEAT TYPE 05, and
WITHOUT SPORT SEATS, and
DOCUMENTATION PHASE 2
IMPORTANT
Before beginning work on any component of the
safety system, it is essential to lock the airbag computer
using the Diagnostic tool (see Airbag and
pretensioners: Precautions
Non-side Opening Element Mechanisms
Bonnet release control: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the wheel arch liners (see 55A, Exterior protection,
Front wheel arch liner: Removal - Refitting, 55A-41),
the front bumper (see 55A, Exterior protection,
Front bumper: Removal - Refitting, 55A-1
© 2016-2025 Copyright Renault Clio Owners Club
