Renault Clio: Wheel: Balancing

I - PREREQUISITES FOR WHEEL BALANCING

Driver's perception

II - BALANCING PREPARATION OPERATION

Renault Clio. Wheel: Balancing

Note: The ring is available from the supplier of the equipment used.

Renault Clio. Wheel: Balancing

  1. Steel wheel with flange
  2. Alloy wheel with flange
  3. Alloy wheel without flange

III - PROCEDURE FOR BALANCING THE WHEEL IN QUESTION

Renault Clio. Wheel: Balancing

Renault Clio. Wheel: Balancing

WARNING

To avoid detachment of the balance weights, use only weights which correspond to the vehicle wheel rims.

IV - FINAL OPERATION

READ NEXT:

 Tyres: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Remove: the wheel in question (see 35A, Wheels and ty

 Tyre pressure: Identification

I - INFLATION WARNING If checking the tyre pressure when hot, increase the recommended pressure by 0.2 to 0.3 bar. B85 or C85 or S85 The pressure values given are recommendations when cold. K85 II

 Wheel rim: Identification

IDENTIFICATION 1 - Marking There are two types of identification marking on the wheel rims: engraved marking for steel wheel rims, cast marking for alloy wheel rims. The marking gives the main dim

SEE MORE:

 Electro-hydraulic unit: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Note: When replacing the electric pump assembly, always replace the control relay. IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, run command " Disc

 Suspended engine mounting: Tightening torque

D4F Tightening torque (in Nm) K4J, and JH3 K4M, and JH3 K4M, and DP0 K9K, and JR5 K9K, and JH3 K9K, and TL4 D4F, and JH3 M4R, and DP0 F4R M4R, and TL4

© 2016-2025 Copyright Renault Clio Owners Club