Renault Clio: Rear light bulb: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the rear light on the wing (see 81A, Rear
lighting, Rear wing light: Removal - Refitting, 81A-5).
B85 or C85 or S85, and DOCUMENTATION
PHASE 1

- Unclip the bulb holder plate (1) by pressing clips (2) and (3).
K85, and DOCUMENTATION PHASE 1

- Unclip the bulb holder plate by pressing clips (4) and (5).
B85 or C85 or S85, and DOCUMENTATION
PHASE 2

- Unclip the bulb holder plate by pressing on the clips (6).
- Remove the bulb holder plate.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
B85 or C85 or S85, and DOCUMENTATION
PHASE 1

- Brake light and side light bulb
- Reversing light bulb
- Direction indicator bulb
- Rear fog light bulb
- Remove the bulbs from the bulb holders.
Note:
The layout of bulbs is the same for both rear
lights.
K85, and DOCUMENTATION PHASE 1

- Brake light and side light bulb
- Direction indicator bulb
- Reversing light bulb
- Remove the bulbs from the bulb holders.
Note:
The layout of bulbs is the same for both rear
lights.
B85 or C85 or S85, and DOCUMENTATION PHASE 2

- Brake light and side light bulb
- Reversing light bulb
- Direction indicator bulb
- Remove the bulbs from the bulb holders.
Note:
The layout of bulbs is the same for both rear
lights.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
Note:
When replacing a bulb, only use approved bulbs.
- Refit the bulbs on the bulb holder plate.
II - FINAL OPERATION
- Clip the bulb holder plate onto the rear light.
- Refit the rear light on the wing.
READ NEXT:
B85 or C85 or S85
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the blanking covers (1).
Insert a screwdriver in the openings to move the clips (2).
Apply pressure to the clips (2)
K85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the tailgate spoiler (see Tailgate spoiler: Removal - Refitting),
the high level brake light (see 81A, Rear lighting,
3rd brake light: Rem
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
K85, and DOCUMENTATION PHASE 1
Move the rear fog light using the tool (Car. 1363) as a lever at (1).
B85 or C85 or S85, and DOCUMENTATION
PHASE 2
SEE MORE:
IMPORTANT
When working in the engine compartment, take
care as the radiator fan(s) may start up unexpectedly
(risk of being cut).
To avoid any risk of serious burns when the engine
is hot:
do not open the expansion bottle cap,
do not drain the cooling system,
do not open the bleed screw(s).
N
M4R
Note:
This engine has two thermostats: one thermostat is
located on the cylinder head and the other is on the
cylinder block.
REMOVAL OF THE CYLINDER HEAD
THERMOSTAT
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lift
© 2016-2025 Copyright Renault Clio Owners Club
