Renault Clio: To lock the system
Renault Clio IV (2014-2019) Owners Manual / Practical advice / Puncture, emergency spare wheel / To lock the system
- Press nut 3, screwing it on fully until it locks in place. Several turns will be necessary. This operation is essential to ensure that the wheel is secure;
- return handle 4 to its original position;
- clip the tool kit;
- replace the cover, then lower it and replace the luggage compartment carpet.
NB: if the tool kit does not lock in place, check the tightness of nut 3 and the correct positioning of handle 4.
Special features
The emergency spare wheel holder should always be present when you are driving even when the wheel itself is not present: risk of water entering the vehicle.
If you have to release it when it is not holding a wheel, push the centre of the wheel holder towards the ground while pressing handle 4.
| It is essential to lock the nut so that the wheel is held securely. |
| The system should only be used with the original vehicle wheels or identical wheels. |
READ NEXT:
Tyre inflation kit
The kit repairs tyres when
tread A has been damaged
by objects smaller
than 4 mm. It cannot repair
all types of puncture, such as cuts
larger than 4 mm, or cuts in tyre
si
Tools
The tools included in the tool kit depend
on the vehicle.
Tool kit A is located in the tray under
the luggage compartment carpet.
Lift the cover and remove it.
Wheelbrace 1
Locks or
Wheel trims - wheel
Remove the wheel trim using hubcap
tool 1 (located in the tool kit) by engaging
the hook in the opening near
valve 2.
To refit it, align it with valve 2. Push the
retaining hooks in fully,
SEE MORE:
Engine oil: Draining - Refilling
D4F or K4J or K4M or K9K
I - RECOMMENDATIONS FOR REPAIR
Direction of fitting of the drain plug seal.
K4J or K4M or K9K
For an aluminium engine oil sump
There is no direction of fitting for a seal fitted with a
rubber lip.
D4F
For a sheet metal engine oil sump
Position the slot (1) of th
Rear brake lining: Removal - Refitting
DRUM BRAKE
Replace all the brake pads on one axle at the same
time. Never mix brake pads of different brands or qualities.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Release the parking bra
© 2016-2025 Copyright Renault Clio Owners Club
