Renault Clio: Crankshaft position sensor: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Diesel Injection / Crankshaft position sensor: Removal - Refitting

K9K, and 764 or 766 or 768

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Crankshaft position sensor: Removal - Refitting

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

II - FINAL OPERATION

K9K, and 750 or 752

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Crankshaft position sensor: Removal - Refitting

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

II - FINAL OPERATION

READ NEXT:

 Preheating

 Pre-postheating unit: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the battery (see Battery: Removal - Refitting), the battery tray (see Battery tray: Removal - Refitting) (MR 392, 80A, Battery). II

 Heater plugs: Removal - Refitting

K9K, and 764 or 772 REMOVAL I - REMOVAL PREPARATION OPERATION Remove the air filter box inlet air pipe (1). Remove the turbocharger outlet air pipe retaining pins (2). Remove: the turbochar

SEE MORE:

 Rear brake disc: Removal - Refitting

DISC BRAKE Brake discs cannot be reground. If there is excessive scoring or wear, they will need to be replaced (see 30A, General information, Brake: Specifications, 30A-9). When replacing a brake disc, be sure to replace the disc on the opposite side. Be sure to replace the brake pads if the bra

 Battery

This is located under cover 1 and does not need to be serviced. Handle the battery with care as it contains sulphuric acid, which must not come into contact with eyes or skin. If it does, wash the affected area with plenty of cold water. If necessary, consult a doctor.

© 2016-2025 Copyright Renault Clio Owners Club