Renault Clio: Rear suspension spring: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components / Rear suspension spring: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting).
- Remove the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Unpick the wheel speed sensor wiring harnesses (1)
- Using a block, bring the component jack into contact under the rear axle, near the shock absorber.
- Mark the position where the springs are fitted.
- Remove the shock absorber lower mounting (2).
- Remove the component jack.
- Repeat these operations on the opposite side.
- Remove the springs by withdrawing the component jack.
- Leave the rear axle suspended.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Using a block, bring the component jack into contact under the rear axle, near the shock absorber.
- Refit the springs in their housing.
- Compress the rear axle.
- Refit the lower shock absorber mounting bolts.
- Torque tighten the shock absorber lower mounting bolts (105 Nm).
- Mount the wheel speed sensor wiring.
II - FINAL OPERATION.
- Remove the component jack.
- Refit the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
READ NEXT:
Rear drum bearing: Removal - Refitting
Using a dial gauge connected to the drum, check that
the end float is greater than 0.03 mm.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
Rear disc bearing: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Put the vehicle on a two-post lift (see Vehicle: Towing and lifting).
Remove:
the rear wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, 3
Rear stub axle carrier: Removal - Refitting
DISC BRAKE
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the rear wheel in questi
SEE MORE:
Brake compensator: Check
WITHOUT ANTI-LOCK BRAKING SYSTEM
CHECK
Position the vehicle on a four-post lift equipped with
an intermediate lifting system (see Vehicle: Towing
and lifting) (MR 392, 02A, Lifting).
I - CHECKING THE DIMENSION OF THE BRAKING
COMPENSATOR ROD IN THE REBOUND POSITION
(WHEELS SUSPENDED)
Raise th
Front centre air distribution duct: Removal -
Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components
(MR 394, 88C, Airbags and pretensioners).
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove:
the driver's front
© 2016-2025 Copyright Renault Clio Owners Club
