Renault Clio: Scoop under the scuttle panel grille: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Mechanisms And Accessories / Exterior Equipment / Scoop under the scuttle panel grille: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

Renault Clio. Scoop under the scuttle panel grille: Removal - Refitting

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Scoop under the scuttle panel grille: Removal - Refitting

Renault Clio. Scoop under the scuttle panel grille: Removal - Refitting

REFITTING

I - REFITTING PREPARATION OPERATION

WARNING

It is essential to replace the foam strips which seal the scoop under the scuttle panel grille. The foam strips are available from the Parts Department.

II - REFITTING OPERATION FOR PART CONCERNED

Renault Clio. Scoop under the scuttle panel grille: Removal - Refitting

Renault Clio. Scoop under the scuttle panel grille: Removal - Refitting

III - FINAL OPERATION

READ NEXT:

 Door mirror: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Unclip the trim (1). II - OPERATION FOR REMOVAL OF PART CONCERNED Remove: the sealing foam (2), the bolts (3) the door mirror. Disconnect th

 Side decorative strips: Removal - Refitting

Note: Once removed, the side decorative strips cannot be refitted and must be replaced each time. REMOVAL I - REMOVAL PREPARATION OPERATION 1 - Front side door Remove: the front side door trim (se

 Sill panel extension: Removal - Refitting

EQUIPMENT LEVEL EAC or EQUIPMENT LEVEL SPORT REMOVAL OPERATION FOR REMOVAL OF PART CONCERNED Remove the bolts (1). Detach the decorative strip (2). Note: Replace the decorative strip (2) ever

SEE MORE:

 Crankshaft seal on timing end: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove the front engine cover. Remove: the scuttle

 Wheel trims - wheel

Remove the wheel trim using hubcap tool 1 (located in the tool kit) by engaging the hook in the opening near valve 2. To refit it, align it with valve 2. Push the retaining hooks in fully, starting with side A near the valve, followed by B and C, finishing at D opposite the valve.

© 2016-2025 Copyright Renault Clio Owners Club