Renault Clio: To the rear seat belts

Force limiter

Above a certain severity of impact, this mechanism is used to limit the force of the belt against the body so that it is at an acceptable level.

  • Have the entire restraint system checked following an accident.
  • No operation whatsoever is permitted on any part of the system (air bags, electronic control units, wiring) and the system components must not be reused on any other vehicle, even if identical.
  • Only qualified personnel from our Network may work on the air bags; otherwise the system may trigger accidentally and cause injury.

READ NEXT:

 Side

Side Airbags This airbag may be fitted to each of the front seats and is activated at the sides of the seats (door side) to protect the occupants in the event of a severe side impact. Dep

 Additional methods of restraint

All of the warnings below are given so that the airbag is not obstructed in any way when it is inflated and also to prevent the risk of serious injuries caused by items which may be dislodged when

 Child safety

SEE MORE:

 Front driveshaft lower arm: Removal - Refitting

EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or EQUIPMENT LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG WARNING Do not use the lower arm for support with a lifting system. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle

 Front side door protective strip: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Unclip the blanking cover (1). Remove the bolt. Remove the side mounted indicator (2) using a small flat screwdriver. Disconnect the power supply connector. II - REMOVAL OPERATION FOR PART CONCERNED Slide the door rubbing strip towards the rear

© 2016-2025 Copyright Renault Clio Owners Club