Renault Clio: B-pillar upper trim: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Trim And Upholstery / Body Internal Trim / B-pillar upper trim: Removal - Refitting
C85
REMOVAL
REMOVAL PREPARATION OPERATION
- Remove:
- the complete rear bench seat,
- the rear wing panel lining (see 71A, Body internal trim, Rear panel lining: Removal - Refitting, 71A-32).
- Remove:
- the bolt (1),
- the seat belt.
- Unclip the height adjustment device (2).
- Remove the covers (3).
- Unclip the trim at (4).
- Remove the B-pillar upper trim.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit the B-pillar upper trim.
- Refit the covers (5).
II - FINAL OPERATION
- Refit the height adjustment device (6).
- Refit the seat belt.
- Tighten to torque the seat belt mounting bolt (21 Nm). (7)
- Refit:
- the rear wing panel lining (see 71A, Body internal trim, Rear panel lining: Removal - Refitting, 71A-32),
- the complete rear bench seat.
READ NEXT:
B-pillar trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Move the seats fully forward.
Partially remove the frame seals (1).
Partially unclip the front and rear door sill trims.
II - REMOVAL OF PART CONCE
Rear inner sill upper trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Partially remove seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the trim at (2) and at (3).
C-pillar upper trim: Removal - Refitting
C85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear wing panel lining (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32),
the rear roof drip moulding lini
SEE MORE:
Side Lower Structure
Sill panel: Description
B85 or K85
To replace this part, also order the expanding inserts
corresponding to each of the following cases.
The options for replacing this part are as follows:
partial replacement of the front end section, order the
exterior A-pillar insert (see 40A, General informat
Oil-coolant heat exchanger: Removal - Refitting
K9K, and 764 or 766 or 768
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the engine protector,
the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
the
© 2016-2025 Copyright Renault Clio Owners Club
