Renault Clio: Front left-hand wiring: Connector access
I - LOCATION OF CONNECTORS

- Connection R 107 (front left-hand wiring/dashboard
wiring connection) composed of two to four connectors
depending on equipment.

- R 374 connector (front left-hand wiring/rear left-hand
wiring connection).

- Connection R 67 (front left-hand wiring/engine wiring
harness connection) composed of two to three
connectors depending on equipment.

- R 33 connector (front left-hand wiring/front bumper
wiring connection).
II - ACCESS TO CONNECTORS
IMPORTANT
Consult the safety and cleanliness advice and
operation recommendations before carrying out
any repair (see 88A, Wiring harness, Wiring:
Precautions for the repair, 88A-5).
WARNING
To prevent damaging the connectors, consult the
disconnection procedure (see Connector: Disconnection
and reconnection) (Technical Note
6015A, 88A, Wiring).
- Switch off the ignition.
- Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, 80A-1).
1 - Access to the R 107 connectors
LEFT-HAND DRIVE

- Remove the dashboard side face (1).

- Remove:
- the dashboard trim piece (2),
- the dashboard lower trim bolt (3).

- Remove:
- the dashboard lower trim bolt (4).
- the dashboard lower trim.

- Disconnect the connectors from connection R 107.
RIGHT-HAND DRIVE
- Remove the glovebox (see Glovebox: Removal -
Refitting) (MR 393, 57A, Interior equipment).

- Disconnect the connectors from connection R 107.
2 - Access to the R 374 connector
- Remove the front left-hand door sill lining (see Front
door sill lining: Removal - Refitting) (MR 393,
71A, Body internal trim).

- Disconnect the R 374 connector.
3 - Access to the R 67 connector

- Remove:
- the bolts (5) from the Protection and Switching Unit
cover,
- the Protection and Switching Unit cover.

- Disconnect the connectors from connection R 67.
4 - Access to the R 33 connector
- Remove the front section of the front left-hand wheel
arch liner (see Front wheel arch liner: Removal -
Refitting) (MR 393, 55A, Exterior protection).

- Disconnect the R 33 connector.
READ NEXT:
LEFT-HAND DRIVE
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
I - LOCATION OF CONNECTORS
R 67 connector (Engine wiring harness/front left-hand
wiring connection).
Depending on the engine, connection R 67 is composed
of three or four connectors.
K4J or K4
SEE MORE:
DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Shift the selector lever to Neutral.
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove:
the front
Your vehicle complies with criteria for
recycling and recovering vehicles at the
end of their service life which will come
into force in 2015.
Some parts of your vehicle have therefore
been designed to facilitate future
recycling.
These parts are easy to remove so
that they can be recove
© 2016-2025 Copyright Renault Clio Owners Club
