Renault Clio: Heating resistors: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the centre console (see Centre console:
Removal - Refitting) (MR 393, 57A, Interior equipment).

- Unclip the trim at (1) and (2) at the base of the dashboard.
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Disconnect the connector (3) from the heating resistors.
- Remove:
- the bolts (4) from the heater resistors,
- the heater resistors.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED

- Refit:
- the heater resistors.
- the bolts (6) from the heater resistors.
- Connect the connector (5) to the heating resistors.
II - FINAL OPERATION.
- Clip on the dashboard lower trim.
- Refit the centre console (see Centre console: Removal
- Refitting) (MR 393, 57A, Interior equipment).
READ NEXT:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(80A, Battery).
Partially remove the seal (1).
Remove the side panel (2).
Remove the
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the centre console (see Centre console:
Removal - Refitting) (MR 393, 57A, Interior equipment).
Unclip the trim at (1) and (2) at the base of t
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(MR 394, 88C, Airbags and pretensioners).
Disconnect
SEE MORE:
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
REMOVAL
I - REMOVAL PREPARATION OPERATION
Raise the window fully.
Switch off the ignition.
Disconnect the battery
EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2
or EQUIPMENT
LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG
When replacing brake pads, be sure to replace the
pads on the opposite side.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the
© 2016-2025 Copyright Renault Clio Owners Club
