Renault Clio: Pump assembly reservoir: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Transmission / Sequential Gearbox / Pump assembly reservoir: Removal - Refitting

K9K, and JA5

REMOVAL

I - REMOVAL PREPARATION OPERATION

IMPORTANT

Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool.

• To discharge the accumulator, run command " Discharge pressure accumulator " AC081.

  To confirm the pressure drop, read the " Hydraulic pressure " parameter for the resulting value.

  If there is still pressure in the accumulator, re-run the " Discharge pressure accumulator " command until the pressure is negligible and will not pose a risk when the high pressure pipes are removed.

  The pressure reading must be close to zero.

• Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment).
• Remove the pump assembly (see 21B, Sequential gearbox, Pump assembly: Removal - Refitting, 21B-12).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Remove:
  • the bolts (1) from the pump assembly reservoir,
  • the reservoir (2) from the pump assembly.

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

• Refit:
  • the pump assembly reservoir,
  • the pump assembly reservoir bolts.
• Torque tighten the pump assembly reservoir bolts (10 Nm).

II - FINAL OPERATION.

• Refit the pump assembly (see 21B, Sequential gearbox, Pump assembly: Removal - Refitting, 21B-12).

D4F, and JA3

REMOVAL

I - REMOVAL PREPARATION OPERATION

IMPORTANT

Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool.

• To discharge the accumulator, run command " Discharge pressure accumulator " AC081.

  To confirm the pressure drop, read the " Hydraulic pressure " parameter for the resulting value.

  If there is still pressure in the accumulator, re-run the " Discharge pressure accumulator " command until the pressure is negligible and will not pose a risk when the high pressure pipes are removed.

  The pressure reading must be close to zero.

• Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment).
• Remove the pump assembly (see 21B, Sequential gearbox, Pump assembly: Removal - Refitting, 21B-12).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Remove:
  • the bolts (1) from the pump assembly reservoir,
  • the reservoir (2) from the pump assembly.

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

• Refit:
  • the pump assembly reservoir,
  • the pump assembly reservoir bolts.
• Torque tighten the pump assembly reservoir bolts (10 Nm).

II - FINAL OPERATION.

• Refit the pump assembly (see 21B, Sequential gearbox, Pump assembly: Removal - Refitting, 21B-12).

READ NEXT: