Renault Clio: Navigation computer: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / On-board Telematics System / Navigation computer: Removal - Refitting

NAVIGATION AID 1 LEVEL

REMOVAL

I - REMOVAL PREPARATION OPERATION

• If the "computer - navigation screen" is being replaced, carry out the necessary operations using the Diagnostic tool (see Fault finding - Replacement of components) (86C, Navigation).
• Switch off the ignition.

WARNING

To prevent damaging the navigation system, wait 1 minute after switching off the + after ignition feed.

WARNING

Do not press on the screen as this may damage it.

• Take the SD card out of its housing.

• Unclip the navigation screen upper trim (1) using the tool (Car. 1363).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Mark the routing of the wiring and the aerials.

WARNING

To ensure correct operation:

• do not pinch the aerial cables,
• do not bend the aerial cables,
• do not force the aerial cables when refitting.

• Mark the aerial position on the unit.
• Disconnect:
  • the connector (2) of the navigation screen,
  • the aerials (3) on the navigation screen,
  • the connector (4) of the seat belt reminder warning light.

• Unclip the multimedia network interface unit from the navigation screen support (5).
• Move aside the multimedia network interface unit.

• Remove the bolts (6) from the " support - navigation screen " assembly.
• Unclip the " support - navigation screen " assembly.
• Remove the " support - navigation screen " assembly.

• Remove the navigation screen bolts (7).
• Unclip the navigation screen from the support.
• Remove the navigation screen.

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

WARNING

Do not press on the screen as this may damage it.

• Refit:
  • the navigation screen on the support,
  • the " support - navigation screen " assembly.
• Fit the multimedia network interface unit.
• Clip on the multimedia network interface unit.

WARNING

To ensure correct operation:

• do not pinch the aerial cables,
• do not bend the aerial cables,
• do not force the aerial cables when refitting.

• Connect:
  • the connector of the navigation screen,
  • the aerials on the navigation screen in the position marked during removal,
  • the connector of the seat belt reminder warning light.
• Refit the wiring in the position marked during removal.

II - FINAL OPERATION

• Clip on the navigation screen upper trim.
• Insert the SD card in its housing.
• Switch on the ignition.
• If the "computer - navigation screen" is being replaced, carry out the necessary operations using the Diagnostic tool (see Fault finding - Replacement of components) (86C, Navigation).
• Check the correct operation:
  • of the seat belt warning light,
  • of the navigation system, if the satellites can be accessed.

READ NEXT: