Renault Clio: Right-hand drive

Renault Clio. Right-hand drive


The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY.

  1. Side air vent.
  2. Passenger Airbag location.
  3. Heating or air conditioning controls.
  4. Multimedia touch-screen.
  5. Windscreen demister outlet.
  6. Hazard warning lights switch.
  7. Door electric locking switch.
  8. Centre air vents.
  9. Stalk:
  1. Instrument panel.
  2. Driver Airbag and horn location.
  3. Multimedia system voice control button.
  4. Stalk:
  1. Side air vent.
  2. Controls for:
  1. Cruise control/speed limiter controls.
  2. Control for adjusting steering wheel height and reach.
  3. Cruise control/speed limiter main control.
  4. Activation/deactivation control for ECO mode.
  5. Handbrake.
  6. Gear lever.
  7. Cigarette lighter/accessories socket.
  8. RENAULT card reader.
  9. Engine start/stop button.
  10. Storage space.
  11. Glovebox.
  12. Bonnet release control.

READ NEXT:

 Warning lights

The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND COUNTRY. Instrument panel A: lights up when the ignition is switched on. The brightness can be adjusted by turning

 Displays and indicators

Rev counter 1 (graduations x 1000) Speedometer 2 (km or miles per hour) Overspeed buzzer Depending on the vehicle, a buzzer sounds for approximately 10 seconds every 40 seconds, as long

 On-board computer: general information

On-board computer 1 Depending on the vehicle, this includes the following functions: distance travelled; journey settings; information messages; operating fault messages (connected t

SEE MORE:

 Filler neck: Removal - Refitting

D4F or F4R or K4J or K4M or K9K or M4R IMPORTANT During this operation, be sure to: be careful of fuel splashes when disconnecting the union. IMPORTANT Wear goggles with side protectors for this operation. IMPORTANT Wear latex gloves during the operation. WARNING To prevent impurities from ente

 Oil level sensor: Removal - Refitting

D4F, and 740 or 742 or 764 REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Move the air inlet hose to one side. Disconnect the connector from the oil level sensor. II - OPERATION FOR REMOVAL OF PART CONCERNED Rem

© 2016-2025 Copyright Renault Clio Owners Club