Renault Clio: Wipers (replacing blades)
Replacing windscreen wiper
blades 1

- With the ignition off, lift wiper arm 2;
- turn blade 1.

Lower tab 3, by pressing on either
side A.
Then push the blade forwards B, to release
hook 4.
To refit
To refit the wiper blade, proceed in reverse
order to removal. Make sure that
the blade is correctly locked in position.
Check the condition of the wiper
blades. You are responsible for their
service life:
- clean the blades, windscreen and
rear screen regularly with soapy
water;
- do not use them when the windscreen
or rear screen are dry;
- free them from the windscreen or
rear screen when they have not
been used for a long time.
|
|
Whilst changing the blade, take care
not to drop the arm onto the window
after it has been removed as this
may break the window. |
Rear screen wiper blade 5

- With the ignition off, lift wiper arm 6;
- release the blade 5 by pulling it.
To refit
To refit the wiper blade, proceed in reverse
order to removal. Make sure that
the blade is correctly locked in position
- In frosty weather, make
sure that the wiper blades
are not stuck by ice (to
avoid the risk of the motor
overheating).
- Check the condition of the wiper
blades.
Replace the wiper blades as soon
as they begin to lose efficiency
(approximately once a year).
Whilst changing the blade, take care
not to drop the arm onto the window
after it has been removed as this
may break the window. |
Check the condition of the wiper
blades. You are responsible for their
service life:
- clean the blades, windscreen and
rear screen regularly with soapy
water;
- do not use them when the windscreen
or rear screen are dry;
- free them from the windscreen or
rear screen when they have not
been used for a long time.
|
READ NEXT:
Before towing, unlock the steering
column: with the clutch depressed,
engage first gear (lever in position N
or R for vehicles with automatic gearboxes),
insert the RENAULT card in the
card reade
With the engine switched off, the transmission
is no longer lubricated. It is
preferable to tow this type of vehicle on
a trailer or tow it with the front wheels
off the ground.
Under exception
Unclip cover 4 or 6 by sliding a flat tool
(or the key integrated in the RENAULT
card) under the cover.
Tighten towing hitch 3 fully: as much
as possible by hand at first, then finish
tight
SEE MORE:
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general informati
FRONT SEAT TYPE 02 or FRONT SEAT TYPE 03 or FRONT SEAT TYPE 05, and
WITHOUT SPORT SEATS, and
DOCUMENTATION PHASE 2
IMPORTANT
Before beginning work on any component of the
safety system, it is essential to lock the airbag computer
using the Diagnostic tool (see Airbag and
pretensioners: Precautions
© 2016-2025 Copyright Renault Clio Owners Club
