Renault Clio: Rear suspension spring: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components / Rear suspension spring: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting).
- Remove the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Unpick the wheel speed sensor wiring harnesses (1)
- Using a block, bring the component jack into contact under the rear axle, near the shock absorber.
- Mark the position where the springs are fitted.
- Remove the shock absorber lower mounting (2).
- Remove the component jack.
- Repeat these operations on the opposite side.
- Remove the springs by withdrawing the component jack.
- Leave the rear axle suspended.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Using a block, bring the component jack into contact under the rear axle, near the shock absorber.
- Refit the springs in their housing.
- Compress the rear axle.
- Refit the lower shock absorber mounting bolts.
- Torque tighten the shock absorber lower mounting bolts (105 Nm).
- Mount the wheel speed sensor wiring.
II - FINAL OPERATION.
- Remove the component jack.
- Refit the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
READ NEXT:
Rear drum bearing: Removal - Refitting
Using a dial gauge connected to the drum, check that
the end float is greater than 0.03 mm.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
Rear disc bearing: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Put the vehicle on a two-post lift (see Vehicle: Towing and lifting).
Remove:
the rear wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, 3
Rear stub axle carrier: Removal - Refitting
DISC BRAKE
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the rear wheel in questi
SEE MORE:
Front driveshaft lower arm: Removal - Refitting
EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2
or EQUIPMENT
LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG
WARNING
Do not use the lower arm for support with a lifting
system.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle
Environment
Your vehicle has been designed with
respect for the environment in mind for
its entire service life: during production,
use and at the end of its life.
This commitment is illustrated by the of
the manufacturer eco² signature.
Manufacture
Your vehicle has been manufactured at
a factory
© 2016-2025 Copyright Renault Clio Owners Club
