Renault Clio: Electro-hydraulic unit: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Transmission / Sequential Gearbox / Electro-hydraulic unit: Removal - Refitting

K9K, and JA5

Renault Clio. Electro-hydraulic unit: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

Note: When replacing the electric pump assembly, always replace the control relay.

IMPORTANT

Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool.

K9K, and JA5

Renault Clio. Electro-hydraulic unit: Removal - Refitting

Note: The electro-hydraulic unit includes the pump assembly and the actuator module.

II - OPERATION FOR REMOVAL OF PART CONCERNED

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

II - FINAL OPERATION

WARNING

After the accumulator has been fully filled (15 seconds after the ignition has been switched on): the oil is at the MIN mark.

D4F, and JA3

Renault Clio. Electro-hydraulic unit: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

Note: When replacing the electric pump assembly, always replace the control relay.

IMPORTANT

Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool.

D4F, and JA3

Renault Clio. Electro-hydraulic unit: Removal - Refitting

Note: The electro-hydraulic unit includes the pump assembly and the actuator module.

II - OPERATION FOR REMOVAL OF PART CONCERNED

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

II - FINAL OPERATION

WARNING

After the accumulator has been fully filled (15 seconds after the ignition has been switched on): the oil is at the MIN mark.

READ NEXT:

 Pump assembly: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Note: When replacing the electric pump assembly, always replace the control relay. IMPORTANT Before any operation on the sequential system, disc

 Solenoid valves: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Note: Before removing the solenoid valves, always mark their respective connectors in order not to mix them up. IMPORTANT Before any operation o

 Engagement sensor: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Batt

SEE MORE:

 Parking Distance Control

Parking distance control: List and location of components REAR PROXIMITY RADAR I - LIST OF COMPONENTS The parking distance control function consists of: rear proximity sensors, a parking distance control buzzer, a parking distance control computer, a parking distance control switch. II - LOCA

 Opening Element Sealing

Door sealing film: Removal - Refitting REMOVAL Note: The sealing film can only be used once; it is destroyed when it is removed. It is essential to replace the film with a new one each time it is removed. REMOVING THE SEALING FILM Remove the door trim( (see Front side door trim: Removal - Refitt

© 2016-2025 Copyright Renault Clio Owners Club