Renault Clio: Heating: List and location of components
Renault Clio III (2005-2013) Service Manual / Air Conditioning / Heating / Heating: List and location of components
LEFT-HAND DRIVE
- Control panel
- Cabin filter
- Rear air distribution duct
- Recirculation control cable
- Air distribution cable
- Air mixing cable
- Air distribution unit
- Heater matrix
- Fan assembly
- Heating resistor relay
- Heating resistors:
- Blower control unit.
- Front side air distribution duct
- Front central air distribution duct
- A-pillar air distribution duct
- External temperature sensor
CLIMATE CONTROL
- Passenger compartment temperature sensor
- Solar radiation sensor
The evaporator is supplied already assembled in the distribution unit. (7)
CLIMATE CONTROL
CLIMATE CONTROL
CLIMATE CONTROL
- Motor-driven fan assembly control unit
- Mixing motor
- Wiring harnesses
- Recirculation motor
- Distribution motor
- Fan assembly
- Cabin filter
- Heater matrix pipes
- Heater matrix
- Heater resistance
- Air distribution unit
- Heater matrix pipe mounting bracket
RIGHT-HAND DRIVE
- Control panel
- Cabin filter
- Rear air distribution duct
- Recirculation control cable
- Air distribution cable
- Air mixing cable
- Air distribution unit
- Heater matrix
- Fan assembly
- Heating resistor relay
- Heating resistors:
- Blower control unit.
- Front side air distribution duct
- Front central air distribution duct
- A-pillar air distribution duct
- External temperature sensor
CLIMATE CONTROL
- Passenger compartment temperature sensor
- Solar radiation sensor
The evaporator is supplied already assembled in the distribution unit. (7)
CLIMATE CONTROL
CLIMATE CONTROL
CLIMATE CONTROL
- Motor-driven fan assembly control unit
- Mixing motor
- Wiring harnesses
- Recirculation motor
- Distribution motor
- Fan assembly
- Cabin filter
- Heater matrix pipes
- Heater matrix
- Heating resistors:
- Air distribution unit
- Heater matrix pipe mounting bracket
READ NEXT:
Cabin filter: Removal - Refitting
LEFT-HAND DRIVE
Note:
The cabin filter is located in the passenger side A-pillar.
REMOVAL
I - REMOVAL PREPARATION OPERATION
SCHOOL VEHICLE
Remove the clutch pedal (see Clutch pedal: Removal
- Refit
Rear air distribution duct: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(MR 394, 88C, Airbags and pretensioners).
Disconnect
Recirculation control cable: Removal - Refitting
LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Partially remove seal (1).
Remove the side panel (2).
Remove the bolt (3) from the base
SEE MORE:
Structural components to be positioned on the repair bench: Description
I - PARTS REQUIRING THE USE OF A BODY JIG
BENCH
Radiator cross member support
Centre floor front side cross member
Front side member closure panel
Front side member
Engine stand
Front half-unit
Front wheel arch
Engine tie-rod attachment
Inner rear wheel arch
Rear side member
Rear sectio
Throttle valve: Cleaning
D4F or F4R or K4J or K4M or M4R
IMPORTANT
Wear leaktight gloves (Nitrile type) for this operation.
IMPORTANT
Always wear protective gear (gloves, goggles and
breathing masks).
Note:
Be sure to work in a clean environment so as not to
allow any contamination of the throttle valve.
CLEANING
I - CLEAN
© 2016-2025 Copyright Renault Clio Owners Club
