Renault Clio: K4J or K4M

Renault Clio. Engine wiring

IMPORTANT

Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5).

WARNING

To prevent damage to the wiring harness when refitting, observe the original routing.

REMOVAL

I - REMOVAL PREPARATION OPERATION

Renault Clio. Engine wiring

II - OPERATION FOR REMOVAL OF PART CONCERNED

WARNING

To prevent any risk of noise, premature wear, short circuits, etc. after the refitting operation, mark the wiring routing and how to connect the connectors.

Renault Clio. Engine wiring

Renault Clio. Engine wiring

JH3 or JR5

Renault Clio. Engine wiring

DP0

Renault Clio. Engine wiring

WARNING

Protect the connector by sliding it into a waterproof plastic bag.

WARNING

To prevent any damage during the removal operation, check that the wiring is free from its mountings (retaining clip, plastic clip, adhesive tape, connector, etc.).

REFITTING

I - REFITTING PREPARATION OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

DP0

JH3 or JR5

 

JH3 or JR5

DP0

 

III - FINAL OPERATION.

READ NEXT:

 K9K

IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5). WARNING To preve

 D4F, and 740 or 764

IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5). WARNING To preve

 F4R

IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5). WARNING To preve

SEE MORE:

 Rear parcel shelf

Removal Lower the rear headrests; unhook the two cords 1 from the boot door; lift the parcel shelf 2 to half height in order to unclip it (movement A); push the shelf in (B movement) and turn it; pull the shelf towards you. To refit, proceed in the reverse order to

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central starting aerial 7 - Rear starting aerial 8 - Start button 9 - Card reader 10 - UCH 11 - Electric ste

© 2016-2025 Copyright Renault Clio Owners Club