Renault Clio: Charge circuit: Specifications

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Starting - Charging / Charge circuit: Specifications

D4F or F4R or K4J or K4M or K9K or M4R

ALTERNATOR SPECIFICATIONS

Renault Clio. Charge circuit: Specifications

Charge circuit: Function

D4F or F4R or K4J or K4M or K9K or M4R

OPERATION

These vehicles are fitted with a built-in regulator and an instrument panel warning light which operates as follows:

when the ignition is switched on, the warning light comes on,
the warning light goes out when the vehicle is started,
if the warning light comes on while the engine is running, it indicates a battery charge fault.

Charge circuit: Check

D4F or F4R or K4J or K4M or K9K or M4R

Check the current after 30 minutes of heating at a voltage of 13.5 V.

Renault Clio. Charge circuit: Check

SEE MORE:

F4R, and Left-hand Drive

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery), the air filter unit (see Air filter unit: Removal - Refit

Starting, Stopping the engine

Remote control RENAULT card When you get into the vehicle, insert the RENAULT card integrated key, pointing towards you, fully into the card reader 2. To start, press button 1. If a gear is engaged, depress the clutch pedal to start the vehicle. Hands-free RENAULT card The RENAULT

Renault Clio: Charge circuit: Specifications

READ NEXT:

Alternator: Removal - Refitting

Starter: Removal - Refitting

Ignition

SEE MORE:

F4R, and Left-hand Drive

Starting, Stopping the engine