Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

Renault Clio. Drive plate: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Drive plate: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

READ NEXT:

 Top And Front Of Engine

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

 Accessories belt: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

SEE MORE:

 Headlight: Removal - Refitting

DISCHARGE LAMPS, and DOCUMENTATION PHASE 1 IMPORTANT To prevent eye injuries: do not look at a xenon bulb when lit (voltage when lit 20000 V), do not light a bulb which has not been fitted into its headlight. IMPORTANT To prevent burns, wait until the " computers - power unit " assemblies are

 Exhaust: List and location of components

PIPE ASSEMBLY D4F, and 740 or 742 or 764 (ZC1) cutting area between the catalytic converter and the expansion chamber (ZC2) cutting area between the expansion chamber and the silencer D4F, and 784 or 786 (ZC1) cutting area between the expansion chamber and the silencer K4J (ZC1) cutting area betw

© 2016-2025 Copyright Renault Clio Owners Club