Renault Clio: Front left-hand wiring: Connector access
Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Wiring Harness / Front left-hand wiring: Connector access
I - LOCATION OF CONNECTORS
- Connection R 107 (front left-hand wiring/dashboard wiring connection) composed of two to four connectors depending on equipment.
- R 374 connector (front left-hand wiring/rear left-hand wiring connection).
- Connection R 67 (front left-hand wiring/engine wiring harness connection) composed of two to three connectors depending on equipment.
- R 33 connector (front left-hand wiring/front bumper wiring connection).
II - ACCESS TO CONNECTORS
IMPORTANT
Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5).
WARNING
To prevent damaging the connectors, consult the disconnection procedure (see Connector: Disconnection and reconnection) (Technical Note 6015A, 88A, Wiring).
- Switch off the ignition.
- Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1).
1 - Access to the R 107 connectors
LEFT-HAND DRIVE
- Remove the dashboard side face (1).
- Remove:
- the dashboard trim piece (2),
- the dashboard lower trim bolt (3).
- Remove:
- the dashboard lower trim bolt (4).
- the dashboard lower trim.
- Disconnect the connectors from connection R 107.
RIGHT-HAND DRIVE
- Remove the glovebox (see Glovebox: Removal - Refitting) (MR 393, 57A, Interior equipment).
- Disconnect the connectors from connection R 107.
2 - Access to the R 374 connector
- Remove the front left-hand door sill lining (see Front door sill lining: Removal - Refitting) (MR 393, 71A, Body internal trim).
- Disconnect the R 374 connector.
3 - Access to the R 67 connector
- Remove:
- the bolts (5) from the Protection and Switching Unit cover,
- the Protection and Switching Unit cover.
- Disconnect the connectors from connection R 67.
4 - Access to the R 33 connector
- Remove the front section of the front left-hand wheel arch liner (see Front wheel arch liner: Removal - Refitting) (MR 393, 55A, Exterior protection).
- Disconnect the R 33 connector.
READ NEXT:
Front left-hand wiring: Removal - Refitting
LEFT-HAND DRIVE
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
Engine wiring: Connector access
I - LOCATION OF CONNECTORS
R 67 connector (Engine wiring harness/front left-hand
wiring connection).
Depending on the engine, connection R 67 is composed
of three or four connectors.
K4J or K4
SEE MORE:
Car Phone
Car phone: List and location of components
CAR PHONE PRE-EQUIPMENT or HANDS-FREE TELEPHONE KIT
I - LIST OF COMPONENTS
The " car phone " consists of:
a telephone aerial
a computer
a "hands-free" microphone
a telephone control on the steering wheel
II - LOCATION OF COMPONENTS
Telephone aerial
T
Rigid brake pipe: Repair
This procedure applies to copper pipes diameter 4.7
mm.
Note:
This procedure does not apply to:
hybrid pipes (pipe + hose),
pipes with diameters 6 mm and 8 mm.
REPAIR
I - PIPE PREPARATION OPERATION
WARNING
To avoid causing a breakdown in hydraulic brake
circuit, do not squash or bend the rigid
© 2016-2025 Copyright Renault Clio Owners Club
