Renault Clio: Manual gearbox: Identification

JA3 or JA5 or JH3 or JR5

K4J / K4M / K9K / D4F engines are fitted with type JH and JR manual gearboxes.

A marking (1) on the gearbox casing indicates:

Renault Clio. Manual Gearbox

  1. Gearbox type
  2. Gearbox suffix
  3. Production plant
  4. Production number

K9K, and TL4 - F4R, and 830, and TL4

Renault Clio. Manual gearbox

  1. Identification plate
  2. Engraving

Renault Clio. Manual gearbox

  1. Gearbox type
  2. Gearbox suffix
  3. Production plant
  4. Production number

Manual gearbox oils: Draining - Filling

JH3 or JR5

Capacity (in litres)

DRAINING

JH3

Renault Clio. Manual gearbox

JR5

Renault Clio. Manual gearbox

FILLING

JH3

Renault Clio. Manual gearbox

JR5

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

Manual gearbox: Specifications

JA3 or JA5 or JH3 or JR5

GEAR RATIOS

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

TL4

GEAR RATIOS

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

READ NEXT:

 Manual gearbox: Removal - Refitting

JH3 or JR5 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). IMPORTANT During this operation, secure the vehicle to the lift wi

 Input shaft lip seal: Removal - Refitting

JH3 or JR5 Replace the lip seal after opening the gearbox (see Technical Note 3661A, gearbox JH - JR). TL4 REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the gearbox (see 21A, Manual gearb

 Differential output seal: Removal - Refitting

JH3 or JR5 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Batter

SEE MORE:

 Engine oil level: topping up, filling

Topping up/filling The vehicle must be parked on level ground and the engine should be cold (for instance, before the engine is started up for the first time in the day). Before performing any action in the engine compartment, the ignition must be switched off by pressing

 Door mirror: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Unclip the trim (1). II - OPERATION FOR REMOVAL OF PART CONCERNED Remove: the sealing foam (2), the bolts (3) the door mirror. Disconnect the supply connectors (depending on equipment level). SCHOOL VEHICLE Unclip the casing (4). R

© 2016-2025 Copyright Renault Clio Owners Club