Renault Clio: Sender: Removal - Refitting

K9K

Renault Clio. Sender: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Sender: Removal - Refitting

WARNING

Refit the sender nut as soon as the sender has been removed to prevent any deformation of the fuel tank.

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

Renault Clio. Sender: Removal - Refitting

II - FINAL OPERATION.

READ NEXT:

 Pump - sender: Removal - Refitting

K9K, and 772 IMPORTANT During this operation, be sure to: beware of fuel splashes when disconnecting the union, protect sensitive areas from fuel outflow. IMPORTANT Wear gloves during this opera

 Pump - sender - filter: Removal - Refitting

D4F or F4R or K4J or K4M or M4R IMPORTANT During this operation, be sure to: be careful of fuel splashes when disconnecting the union. IMPORTANT Wear goggles with side protectors for this operati

 Engine Mounting

SEE MORE:

 Running in

Petrol version For the first 600 miles (1,000 km), do not exceed 78 mph (130 km/h) in the highest gear, or 3,000 to 3,500 rpm. You may only expect top performance from your vehicle after approximately 1,800 miles (3,000 km). Service intervals: refer to the Maintenance Document for your v

 Front right-hand driveshaft gaiter, gearbox side: Removal - Refitting

DP0 or JH3 or JR5 or TL4 Deflector Propeller shaft Driveshaft yoke sleeve Spider RC gaiter Tightening clip Lock ring Tightening ring REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Di

© 2016-2025 Copyright Renault Clio Owners Club