Renault Clio: Start button: Removal - Refitting
VEHICLE WITH CARD

REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the centre console (see Centre console:
Removal - Refitting) (MR 393, 57A, Interior equipment).

- Unclip the trim at (1) and (2).
RADIO NO. 01 or RADIO NO. 02 or RADIO NO.03
or RADIO NO. 04 or RADIO NO. 05 or RADIO NO.06
- Remove the radio (see 86A, Radio, Radio: Removal
- Refitting, 86A-8).
NAVIGATION AID 1
- Remove the radio navigation system (see 83C, On-board
telematics system, Radio navigation: Removal
- Refitting, 83C-3).
WITHOUT NAVIGATION AID, and VEHICLE WITHOUT
RADIO
- Unclip the glovebox using the (Car. 1363).

- Unclip the centre front panel at (3).

- Unclip the centre front panel at (4).
- Disconnect the connectors.
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the start button (5).
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Clip the start button onto the centre front cover.
II - FINAL OPERATION.
- Connect the centre front panel connectors.
- Clip in the centre front panel beginning with the lower
section.
RADIO NO. 01 or RADIO NO. 02 or RADIO NO.03
or RADIO NO. 04 or RADIO NO. 05 or RADIO NO.06
- Refit the radio (see 86A, Radio, Radio: Removal -
Refitting, 86A-8).
NAVIGATION AID 1
- Refit the radio navigation system (see 83C, On-board
telematics system, Radio navigation: Removal
- Refitting, 83C-3).
WITHOUT NAVIGATION AID, and VEHICLE WITHOUT
RADIO
- Clip the glovebox in position.
- Clip the trim under the centre front panel.
- Refit the centre console (see Centre console: Removal
- Refitting) (MR 393, 57A, Interior equipment).
READ NEXT:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lock the airbag computer using the Diagnostic tool
to unlock the steering column lock (see Fault finding
- Replacement of components) (MR 394, 88C,
Airb
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
VEHICLE WITH KEY
Remove the bolt (1).
Open the key with a coin (2).
VEHICLE WITH CARD
Remove the mechanical insert (3).
REFITTING
I - REFITT
VEHICLE WITH CARD
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the centre console (see Centre console:
Removal - Refitting) (MR 393, 57A, Interior equipment).
Unclip the trim at (1) and (2
SEE MORE:
D4F or K9K, and JA3 or JA5
I - SEQUENTIAL GEARBOX
WARNING
If any operation is carried out on the electro-hydraulic
unit, it is essential to clean the unit using a cleaning
product and compressed air.
Never leave the circuit open and never use a high
pressure cleaner.
II - SEQUENTIAL GEARBOX COMPUT
LEFT-HAND DRIVE
REMOVAL
I - REMOVAL PREPARATION OPERATION
Put the vehicle on a two-post lift (see Vehicle: Towing and lifting).
Disconnect the battery (see Battery: Removal - Refitting).
Fit a pedal press on the brake pedal.
K4J or K4M or K9K
Remove the battery (see Battery: Removal - Refit
© 2016-2025 Copyright Renault Clio Owners Club
