Renault Clio: Right-hand drive

The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY.
- Side air vent.
- Passenger Airbag location.
- Heating or air conditioning controls.
- Multimedia touch-screen.
- Windscreen demister outlet.
- Hazard warning lights switch.
- Door electric locking switch.
- Centre air vents.
- Stalk:
- direction indicator lights;
- exterior lights;
- front fog lights;
- rear fog lights.
- Instrument panel.
- Driver Airbag and horn location.
- Multimedia system voice control
button.
- Stalk:
- windscreen and rear screen
wash/wipe;
- trip computer and warning
system information readout.
- Side air vent.
- Controls for:
- electric headlight beam adjustment,
- instrument panel lighting dimmer,
- activate/deactivate the parking
distance control system,
- activation/deactivation of the Stop
and Start function.
- Cruise control/speed limiter controls.
- Control for adjusting steering
wheel height and reach.
- Cruise control/speed limiter main
control.
- Activation/deactivation control for
ECO mode.
- Handbrake.
- Gear lever.
- Cigarette lighter/accessories
socket.
- RENAULT card reader.
- Engine start/stop button.
- Storage space.
- Glovebox.
- Bonnet release control.
READ NEXT:
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT
AND COUNTRY.
Instrument panel A: lights up when
the ignition is switched on. The brightness
can be adjusted by turning
Rev counter 1
(graduations x 1000)
Speedometer 2
(km or miles per hour)
Overspeed buzzer
Depending on the vehicle, a buzzer
sounds for approximately 10 seconds
every 40 seconds, as long
On-board computer 1
Depending on the vehicle, this includes
the following functions:
distance travelled;
journey settings;
information messages;
operating fault messages (connected
t
SEE MORE:
LEFT-HAND DRIVE
REMOVAL
I - REMOVAL PREPARATION OPERATION
K4J or K4M or K9K
Remove:
the battery (see Battery: Removal - Refitting),
the air filter box (see Air filter unit: Removal - Refitting).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Fit a hose clamp on the connection between the
JH3 or JR5
Note:
Each time an operation is carried out on the
hydraulic clutch system, bleed the circuit:
between the reservoir and the bleed hole,
between the bleed hole and the clutch release
bearing.
REMOVAL
I - REMOVAL PREPARATION OPERATION
K4J or K4M
Remove the resonator.
Remov
© 2016-2026 Copyright Renault Clio Owners Club - 0.0051
