Renault Clio: Scuttle panel grille: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the wiper arms (see Windscreen wiper
arm: Removal - Refitting) (MR 392, Mechanical
systems, 85A, Washing - Wiping).

II - OPERATION FOR REMOVAL OF PART
CONCERNED


- Remove the scuttle panel grille (3) and (4).
REFITTING
I - REFITTING PREPARATION OPERATION
Note:
Check that the windscreen and the scuttle panel
grille are clean before refitting.
II - REFITTING OPERATION FOR PART
CONCERNED

- Refit:
- the scuttle panel grille,
- the clips (5).
III - FINAL OPERATION.

- Refit:
- the seal (6),
- the wiper arms (see Windscreen wiper arm: Removal
- Refitting) (MR 392, Mechanical systems,
85A, Washing - Wiping).
READ NEXT:
K85
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Remove:
the blanking covers (1),
the nuts (2).
Unclip the tailgate spoiler at (3).
Disconnect:
the high level brake light connecto
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the scuttle panel grille (see 56A, Exterior
equipment, Scuttle panel grille: Removal - Refitting, 56A-1).
Remove the trim under the scuttle pane
REMOVAL
I - REMOVAL PREPARATION OPERATION
Unclip the trim (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove:
the sealing foam (2),
the bolts (3)
the door mirror.
Disconnect th
SEE MORE:
D4F, and 740 or 742 or 764
Petrol vapour rebreathing solenoid
valve
Air inlet pressure sensor
Motorised throttle valve
Injection computer
(5) Fuel injection computer
(6) Motorised throttle valve
(7) Fuel vapour recirculation solenoid
valve
(8) Ignition coil
(9) Upstream oxygen sensor
(1
D4F, and 740
WARNING
Do not use any product designed to improve electrical
contact in the injection computer connectors
and oxygen sensors and on the oxygen sensor
body. Failure to respect this advice prevents the
oxygen sensor from operating correctly and results
in failure to comply with the emis
© 2016-2026 Copyright Renault Clio Owners Club - 0.004
