Renault Clio: Boot storage
Renault Clio IV (2014-2019) Owners Manual / Your comfort / Boot storage
Mobile floor
When fitted to the vehicle, it can be used to make loading easier.
Note: if you need to access the ISOFIX ring and/or the net ring at the bottom of the boot, open flap 3.
| Maximum weight for the mobile floor: 100 kg evenly distributed. |
Movable floor storage
- Lower section 1 onto section 2;
- lift the assembly and position it against the back of the rear bench seat;
- push the catch 4 to lock the mobile floor in the folded position.
Removing the mobile floor
- Lower section 1 onto section 2;
- remove the assembly.
Repositioning the mobile floor
Position it in the boot, using the 5 runners provided.
READ NEXT:
Transporting objects in the boot
Always position the objects transported
so that the largest surface is against:
The rear bench seatback for normal
loads (example A).
The front seatbacks with the rear
seatbacks
Towing, attachments
Permissible nose weight, maximum
permissible towing weight,
braked and unbraked: refer to
the information on “Weights” in
Section 6.
For fitting and conditions of use,
SEE MORE:
Particle filter temperature sensors: Removal -
Refitting
K9K, and 772
The particle filter must be removed in order to remove
the catalytic converter upstream temperature sensor.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02, Lifting equipment).
Disconnect the battery (s
Exhaust fuel injector: Removal - Refitting
K9K, and 772
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair:
see Exhaust: Precautions for repair (19B,
Exhaust),
see Vehicle: Precautions for repair (01D,
Mechanical introduction).
© 2016-2026 Copyright Renault Clio Owners Club - 0.0045
