Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Remove the gearbox (see 23A, Automatic gearbox, Automatic gearbox: Removal - Refitting, 23A-7).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Set up the (Mot. 582-01) (2).
• Remove:
  • the bolts (2),
  • the drive plate,
  • tool (Mot. 582-01).

REFITTING

I - REFITTING PREPARATIONS OPERATION

• Check that the drive plate is not damaged (run-out tolerance of 0.2 mm on the outer diameter).

II - REFITTING OPERATION FOR PART CONCERNED

• Fit the drive plate, ensuring it is correctly positioned in relation to the centring pins.
• Apply LOCTITE FRENBLOC to the bolt threads.
• Tighten the bolts on the drive plate.
• Torque and angle tighten the drive plate bolts (55 Nm + 50

  READ NEXT:

   Multifunction switch: Removal - Refitting

  DP0 REMOVAL I - REMOVAL PREPARATION OPERATION Shift the selector lever to Neutral. Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove the battery tray (se

   Speed sensor: Removal - Refitting

  DP0 Do not drain or remove the automatic gearbox in order to remove the speed sensor. The output speed sensor has been deleted and replaced with wheel speed sensors. REMOVAL I - REMOVAL PREPARATION

   Pressure sensor: Removal - Refitting

  DP0 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on the two-post lift (see 02A, Lifting equipment, Vehicle: Towing and lifting). Disconnect the battery (see 80A, Battery, Batter

  SEE MORE:

    Reverse gear switch: Removal - Refitting

  TL4 REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the battery (see Battery: Removal - Refitting) (80A, Battery), the battery tray (see Battery tray: Removal - Refitting) (80A, Battery). II - OPERATION FOR REMOVAL OF PART CONCERNED Disconnect the connector (1) from the reverse

    Sequential gearbox: Precautions for the repair

  D4F or K9K, and JA3 or JA5 I - SEQUENTIAL GEARBOX WARNING If any operation is carried out on the electro-hydraulic unit, it is essential to clean the unit using a cleaning product and compressed air. Never leave the circuit open and never use a high pressure cleaner. II - SEQUENTIAL GEARBOX COMPUT