{MAINCONT}

Renault Clio: Charge circuit: Specifications

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Starting - Charging / Charge circuit: Specifications

D4F or F4R or K4J or K4M or K9K or M4R

ALTERNATOR SPECIFICATIONS

Renault Clio. Charge circuit: Specifications

Charge circuit: Function

D4F or F4R or K4J or K4M or K9K or M4R

OPERATION

These vehicles are fitted with a built-in regulator and an instrument panel warning light which operates as follows:

when the ignition is switched on, the warning light comes on,
the warning light goes out when the vehicle is started,
if the warning light comes on while the engine is running, it indicates a battery charge fault.

Charge circuit: Check

D4F or F4R or K4J or K4M or K9K or M4R

Check the current after 30 minutes of heating at a voltage of 13.5 V.

Renault Clio. Charge circuit: Check

SEE MORE:

Driveshaft: Precautions for the repair

DP0 or JH3 or JR5 or TL4 WARNING A gearbox oil leak at the driveshaft may destroy it. WARNING Always replace seals whenever the driveshaft is removed. WARNING Grease the base of the bearing using BR 2 + grease to prevent the bearing from sticking. Make sure that the O-ring is correctly positioned i

Relay shaft bearing: Removal - Refitting

M4R, and TL4 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove the front right-hand driveshaft (see 29A,

{VIDEOCONT}

Renault Clio: Charge circuit: Specifications

READ NEXT:

Alternator: Removal - Refitting

Starter: Removal - Refitting

Ignition

SEE MORE:

Driveshaft: Precautions for the repair

Relay shaft bearing: Removal - Refitting