Renault Clio: Input shaft lip seal: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Transmission / Manual Gearbox / Input shaft lip seal: Removal - Refitting
JH3 or JR5
- Replace the lip seal after opening the gearbox (see Technical Note 3661A, gearbox JH - JR).
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the gearbox (see 21A, Manual gearbox, Manual gearbox: Removal - Refitting, 21A-12),
- the clutch thrust bearing (see 20A, Clutch, Clutch thrust bearing: Removal - Refitting, 20A- 11).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Drill a hole in the seal, using a 2.5 mm drill bit.
WARNING
Do not scratch the shaft or mating face.
- Fit a bolt in seal (1).
- Extract the seal (1) using pliers.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Fit a new seal with its protector using the (Bvi.1601).
- Remove the protector.
II - FINAL OPERATION
- Refit:
- the clutch thrust bearing (see 20A, Clutch, Clutch thrust bearing: Removal - Refitting, 20A- 11).
- the gearbox (see 21A, Manual gearbox, Manual gearbox: Removal - Refitting, 21A-12).
READ NEXT:
Differential output seal: Removal - Refitting
JH3 or JR5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Batter
Reverse gear switch: Removal - Refitting
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the battery (see Battery: Removal - Refitting)
(80A, Battery),
the battery tray (see Battery tray: Removal - Refitting)
(80A, Battery).
SEE MORE:
Remote headlight beam adjustment actuator: Removal - Refitting
DOCUMENTATION PHASE 1
DISCHARGE LAMPS
IMPORTANT
To prevent burns, wait until the " computers -
power unit " assemblies are cold before removal.
IMPORTANT
To prevent eye injuries:
do not look at a xenon bulb when lit (voltage
when lit 20000 V),
do not light a bulb which has not been fitted into
Headlight beam adjustment front sensor: Removal - Refitting
DISCHARGE LAMPS
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a lift (see Vehicle: Towing
and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the front wheels (see Wheel: Removal - Refitting)
(MR 392, 35A, Wheels and tyres),
the front axle subframe (see Front axle s
© 2016-2026 Copyright Renault Clio Owners Club - 0.0034
