Renault Clio: High level brake light bulb: Removal - Refitting
K85
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the tailgate spoiler (see Tailgate spoiler: Removal - Refitting),
- the high level brake light (see 81A, Rear lighting,
3rd brake light: Removal - Refitting, 81A- 10).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove:
- the bulb holder by pressing on the clips (1),
- the bulbs.
Note:
When replacing bulbs, use approved W5W bulbs.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Clip:
- the bulbs into the bulb holder,
- the bulb holder onto the high-level brake light.
II - FINAL OPERATION.
- Refit:
- the high level brake light (see 81A, Rear lighting,
3rd brake light: Removal - Refitting, 81A- 10),
- the tailgate spoiler (see Tailgate spoiler: Removal - Refitting).
B85 or C85 or S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the high level brake light (see 81A, Rear
lighting, 3rd brake light: Removal - Refitting, 81A-10).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the bulb (1) from the bulb holder.
Note:
When replacing the bulb, use an approved
W16W bulb.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit the bulb in the bulb holder.
II - FINAL OPERATION.
- Refit the high level brake light (see 81A, Rear lighting,
3rd brake light: Removal - Refitting, 81A-10).
READ NEXT:
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
K85, and DOCUMENTATION PHASE 1
Move the rear fog light using the tool (Car. 1363) as a lever at (1).
B85 or C85 or S85, and DOCUMENTATION
PHASE 2
Interior lighting: Function
I - GENERAL INFORMATION
Vehicles may be fitted with the following units for lighting
the interior of the passenger compartment, depending
on the level of equipment:
a cou
Fuses: List and location of components
Passenger compartment fuse and
relay box
Consumer cut-out fuse
Additional relay/fuse box
Battery protection fuses
Protection and switching unit
Power sup
SEE MORE:
With the engine switched off and on
level ground, the level when cold must
be between the MINI and MAXI marks
on reservoir 1.
Top this level up when cold before it
reaches the MINI mark.
When working in the engine
compartment, ensure that
the windscreen wiper stalk
is in
AIR CONDITIONING or CLIMATE CONTROL
Note:
Before removal, use DIALOGYS to check how the
condenser is fitted and arranged.
There are 2 possibilities:
the condenser and cooling radiator cannot be separated,
the condenser and cooling radiator can be separated.
IMPORTANT
To avoid all risk of damag
© 2016-2025 Copyright Renault Clio Owners Club
