Renault Clio: Rear suspension spring: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components / Rear suspension spring: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting).
- Remove the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Unpick the wheel speed sensor wiring harnesses (1)
- Using a block, bring the component jack into contact under the rear axle, near the shock absorber.
- Mark the position where the springs are fitted.
- Remove the shock absorber lower mounting (2).
- Remove the component jack.
- Repeat these operations on the opposite side.
- Remove the springs by withdrawing the component jack.
- Leave the rear axle suspended.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Using a block, bring the component jack into contact under the rear axle, near the shock absorber.
- Refit the springs in their housing.
- Compress the rear axle.
- Refit the lower shock absorber mounting bolts.
- Torque tighten the shock absorber lower mounting bolts (105 Nm).
- Mount the wheel speed sensor wiring.
II - FINAL OPERATION.
- Remove the component jack.
- Refit the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
READ NEXT:
Rear drum bearing: Removal - Refitting
Using a dial gauge connected to the drum, check that
the end float is greater than 0.03 mm.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
Rear disc bearing: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Put the vehicle on a two-post lift (see Vehicle: Towing and lifting).
Remove:
the rear wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, 3
Rear stub axle carrier: Removal - Refitting
DISC BRAKE
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the rear wheel in questi
SEE MORE:
Wipers (replacing blades)
Replacing windscreen wiper
blades 1
With the ignition off, lift wiper arm 2;
turn blade 1.
Lower tab 3, by pressing on either
side A.
Then push the blade forwards B, to release
hook 4.
To refit
To refit the wiper blade, proceed in reverse
order to removal. Make sure that
t
Dehydrator reservoir: Removal - Refitting
AIR CONDITIONING or CLIMATE CONTROL
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair:
(see 62A, Air conditioning, Air conditioning:
Precautions for the repair, 62A-1),
(se
© 2016-2025 Copyright Renault Clio Owners Club
