Renault Clio: Rear left-hand side door wiring: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Wiring Harness / Rear left-hand side door wiring: Removal - Refitting

B85 or K85

IMPORTANT

Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5).

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Raise the window fully.
• Switch off the ignition.
• Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1).

WARNING

To prevent damaging the connectors, consult the disconnection procedure (see Connector: Disconnection and reconnection) (Technical Note 6015A, 88A, Wiring).

• Remove:
  • the rear side door trim (see Rear side door trim: Removal - Refitting) (MR 393, 72A, Side opening element trim),
  • the rear speaker (see 86A, Radio, Rear speakers: Removal - Refitting, 86A-15),
  • the door sealing film (see Door sealing film: Removal - Refitting) (MR 393, 65A, Opening element sealing),
  • the rear side door lock (see Rear side door lock: Removal - Refitting) (MR 393, 51A, Side opening element mechanisms).

II - OPERATION FOR REMOVAL OF PART CONCERNED

WARNING

To prevent any risk of noise, premature wear, short circuits, etc. after the refitting operation, mark the wiring routing and how to connect the connectors.

• Disconnect the R 13 connector for connection of rear left-hand wiring/left-hand rear door.

VEHICLE WITH CARD

• Disconnect:
  • the presence detector connector (1),
  • the opening aerial connector (2).

ELECTRIC REAR WINDOW

• the (3) rear side door electric window winder mechanism connector.

• Unclip the rear side door wiring in (4).
• Remove the rear side door wiring.

WARNING

To prevent any damage during the removal operation, check that the wiring is free from its mountings (retaining clip, plastic clip, adhesive tape, connector, etc.).

REFITTING

I - REFITTING PREPARATION OPERATION

• If replacing with more wiring, lock the unused connectors (see Connector: Sealing and immobilisation) (Technical Note 6015A, 88A, Wiring).

II - REFITTING OPERATION FOR PART CONCERNED

• Refit the rear side door wiring.
• Clip on the rear side door wiring (4).

ELECTRIC REAR WINDOW

• Connect the rear side door electric window winder mechanism connector.

VEHICLE WITH CARD

• Connect:
  • the opening aerial connector,
  • the presence detector connector.

• Connect the rear left-hand wiring/left rear door R 13 connector.

III - FINAL OPERATION.

• Refit:
  • the rear side door lock (see Rear side door lock: Removal - Refitting) (MR 393, 51A, Side opening element mechanisms).
  • the door sealing film (see Door sealing film: Removal - Refitting) (MR 393, 65A, Opening element sealing),
  • the rear speaker (see 86A, Radio, Rear speakers: Removal - Refitting, 86A-15),
  • the rear side door trim (see Rear side door trim: Removal - Refitting) (MR 393, 72A, Side opening element trim),
• Connect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1).

READ NEXT: