Renault Clio: Rear panel lining: Removal - Refitting
C85 or S85

REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the complete rear bench seat.

- Remove:
- the front seat belt support bolt (1).
- the front seat belt support.

- Unclip:
- the rear section of the front door sill lining (3),
- the rear wing panel trim at (4).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the rear wing panel trim at (7), (8) and (9).
REFITTING
I - REFITTING PREPARATION OPERATION
- Always replace the front seat belt support bolt.
II - REFITTING OPERATION FOR PART
CONCERNED
- Clip on the rear wing panel trim.
C85

- Refit:
- the speaker,
- the bolts (10).

- Clip on the speaker grille.
III - FINAL OPERATION.
- Clip on the front door sill lining.
- Refit the front seat belt support.
- Torque tighten the front seat belt support bolt (21
Nm).
READ NEXT:
REMOVAL
I - REMOVAL PREPARATION OPERATION
C85
Remove the rear wing panel trim (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32).
B85
Unclip the rear inner sill upper
REMOVAL
I - REMOVAL PREPARATION OPERATION
B85 or C85 or S85
Remove the luggage compartment carpet.
K85
Remove the luggage compartment raised floor (1).
Remove the luggage compartment carpe
S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear parcel shelf,
the centre rear parcel shelf (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the clips (2).
Remove
SEE MORE:
K9K
Remove the heater plugs (see 13C, Preheating,
Heater plugs: Removal - Refitting, 13C-2).
Disconnect:
the pressure regulation solenoid valve connector (1),
the flow control solenoid valve connector (2),
Fit the hose end piece (Mot. 1592) in place of one of
the removed plugs.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the front bumper (see 55A, Exterior protection,
Front bumper: Removal - Refitting, 55A-1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the bonnet catch bolts (1).
Remove the clip (2) using offset adjusting pliers.
Unclip the sheat
© 2016-2025 Copyright Renault Clio Owners Club
