Renault Clio: Sender: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Tank / Sender: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02, Lifting equipment).
- Drain the fuel tank (see 19C, Tank, Fuel tank: Draining, 19C-8).
- Remove the battery covers.
- Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).
- Remove the fuel tank (see 19C, Tank, Fuel tank: Removal - Refitting, 19C-1).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove the mounting nut from the sender unit using (Mot. 1397)
- Let the fuel drain from the sender.
- Remove the sender unit, being careful with the float.
WARNING
Refit the sender nut as soon as the sender has been removed to prevent any deformation of the fuel tank.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Replace the O-ring.
- Refit the pump - sender by positioning the mark (1) on the sender opposite the mark (2) on the tank.
- Position the sender mounting nut.
- Tighten the sender mounting nut using the (Mot.1397) until the mark on the nut (3) lines up with the mark (2) on the tank and the mark (1) on the sender.
II - FINAL OPERATION.
- Refit the fuel tank (see 19C, Tank, Fuel tank: Removal - Refitting, 19C-1).
- Connect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).
READ NEXT:
Pump - sender: Removal - Refitting
K9K, and 772
IMPORTANT
During this operation, be sure to:
beware of fuel splashes when disconnecting the
union,
protect sensitive areas from fuel outflow.
IMPORTANT
Wear gloves during this opera
Pump - sender - filter: Removal - Refitting
D4F or F4R or K4J or K4M or M4R
IMPORTANT
During this operation, be sure to:
be careful of fuel splashes when disconnecting the
union.
IMPORTANT
Wear goggles with side protectors for this operati
SEE MORE:
To the rear seat belts
Force limiter
Above a certain severity of impact, this
mechanism is used to limit the force of
the belt against the body so that it is at
an acceptable level.
Have the entire restraint
system checked following
an accident.
No operation whatsoever
is permitted on
Rear drum bearing: Removal - Refitting
Using a dial gauge connected to the drum, check that
the end float is greater than 0.03 mm.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
Remove:
the rear wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, 35
© 2016-2025 Copyright Renault Clio Owners Club
