Renault Clio: Front door sill lining: Removal - Refitting
B85 or C85
REMOVAL
I - REMOVAL PREPARATION OPERATION

- Partially remove the seal (1).

- Using a pair of unclipping pliers, unclip the bonnet release catch (2).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the trim at (3) and (4).
- Remove the trim (5).
C85

- Unclip the trim at (6) and (7).
- Remove the front door sill linings.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit the front door sill trim.
II - FINAL OPERATION.
- Refit the bonnet release handle.

Rear door sill lining: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the complete rear bench seat.
- Partially unclip the front door sill trim (see 71A,
Body internal trim, Front door sill lining: Removal
- Refitting, 71A-10).
- Remove the rear door sill upper trim (see 71A, Body
internal trim, Rear inner sill upper trim: Removal
- Refitting, 71A-24).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove clip (1) using the unclipping pliers.
- Unclip the trim at (2) and at (3).
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit the door sill trim.
- Refit the mounting clip.
II - FINAL OPERATION
- Refit:
- the rear door sill upper trim (see 71A, Body internal
trim, Rear inner sill upper trim: Removal -
Refitting, 71A-24).
- the front door sill trims (see 71A, Body internal
trim, Front door sill lining: Removal - Refitting, 71A-10),
- the complete rear bench seat.
READ NEXT:
B85 or C85
IMPORTANT
Consult the safety and cleanliness advice and
operation recommendations before carrying out
any repair (see Airbag and pretensioners: Precautions
for the repair) (88C, Airbags an
REMOVAL
I - REMOVAL PREPARATION OPERATION
Partially remove the seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the top of the pillar trim at (2).
remove the pillar trim by pul
C85
REMOVAL
REMOVAL PREPARATION OPERATION
Remove:
the complete rear bench seat,
the rear wing panel lining (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32).
SEE MORE:
K4J or K4M, and 780 or 800 or 801
Oil vapour rebreathing duct
Calibrated port
Oil vapour recovery plate
located on the rocker cover
Oil vapour rebreathing hole
Oil vapour rebreathing circuit: Operating diagram
K4J, and 780 - K4M, and 800 or 801
A: under low loads, the oil vapours are rebr
With the engine switched off, the transmission
is no longer lubricated. It is
preferable to tow this type of vehicle on
a trailer or tow it with the front wheels
off the ground.
Under exceptional circumstances, you
may tow the vehicle with all four wheels
on the ground, only going forward,
© 2016-2025 Copyright Renault Clio Owners Club
