Renault Clio: Gear selection sensor: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Transmission / Sequential Gearbox / Gear selection sensor: Removal - Refitting

K9K, and JA5

Renault Clio. Gear selection sensor: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

WARNING

To remove the gear selection sensor it is essential that you shift to first gear before removal.

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Gear selection sensor: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

III - FINAL OPERATION.

D4F, and JA3

Renault Clio. Gear selection sensor: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

WARNING

To remove the gear selection sensor it is essential that you shift to first gear before removal.

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Gear selection sensor: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

III - FINAL OPERATION.

READ NEXT:

 Clutch position sensor: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Batte

 Solenoid valve assembly pressure sensor: Removal - Refitting

K9K, and JA5 REMOVAL REMOVAL PREPARATION OPERATION IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, run co

 Sequential gearbox engine speed sensor: Removal - Refitting

D4F, and JA3 REMOVAL I - REMOVAL PREPARATION OPERATION IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, ru

SEE MORE:

 Side Lower Structure

Sill panel: Description B85 or K85 To replace this part, also order the expanding inserts corresponding to each of the following cases. The options for replacing this part are as follows: partial replacement of the front end section, order the exterior A-pillar insert (see 40A, General informat

 Clutch pedal switch: Removal - Refitting

JH3 or JR5 or TL4, and CRUISE CONTROL - JH3 or JR5 or TL4, and VEHICLE WITH CARD REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the driver side dashboard lower trim clips (1), the driver side dashboard lower trim (2). II - OPERATION FOR REMOVAL OF PART CONCERNED CRUISE CONTROL Dis

© 2016-2025 Copyright Renault Clio Owners Club