Renault Clio: Manual gear control: Adjustment
TL4
ADJUSTMENT
ADJUSTMENT OF SELECTION CABLE DURING A
REMOVAL OPERATION
1 - Passenger compartment
- Shift the selector lever to third gear.

- Fit a shim (1) (6 mm between the locking ring and
reverse gear interlock on the selector lever.
- Use a strap (2) to immobilise the lever against the
shim in third gear position.
2 - Engine compartment
- Position the gear lever on the gearbox in "third gear
engaged" position.

- Unlock the selector cable adjustment clip by compressing
the lock ring (3) and push the orange clip
(4) upwards
(1).
- Adjust the length of the cable accordingly and fit it
onto the gear selection lever ball joint.

- Lock the cable by pressing on the orange clip (5).
- Check that gear selection is correct.
READ NEXT:
F4R or K4J or K4M or K9K or M4R, and LEFT-HAND DRIVE
WARNING
Prepare for brake fluid outflow, to prevent damage
to the mechanical parts and bodywork around the
braking system.
REMOVAL
I - REMOVAL PRE
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
SEE MORE:
Side lights
Turn the ring 2 until the symbol
is opposite mark 3.
An indicator light on the instrument
panel will come on.
Daytime running lights function
(front lights only)
Depending on the vehicle, the daytime
running lights come on automatically
when the engine is started.
The replacement of filter components
(air filter, cabin filter, diesel filter, etc.)
is scheduled in the maintenance operations
for your vehicle.
Replacement intervals for filter elements:
refer to the Maintenance
Document for your vehicle.
Before performing any
action in the engi
© 2016-2025 Copyright Renault Clio Owners Club
