Renault Clio: Rear brake hose: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components / Rear brake hose: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment).
WARNING
Prepare for brake fluid outflow, to prevent damage to the mechanical parts and bodywork around the braking system.
- Fit the pedal press to the brake pedal to limit the outflow of brake fluid.
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove:
- the unions (1) from the pipe concerned,
- the pipe concerned.
REFITTING
I - REFITTING PREPARATIONS OPERATION
WARNING
Do not twist the brake hose.
Make sure that there is no contact between the brake hose and the surrounding components.
II - REFITTING OPERATION FOR PART CONCERNED
- Refit the hose.
- Torque tighten the brake hose unions (14 Nm).
III - FINAL OPERATION.
- Remove the pedal press from the brake pedal.
- Bleed the brake circuit (see 30A, General information, Braking circuit: Bleed, 30A-4).
- Check the brake fluid level.
READ NEXT:
Rear brake calliper: Repair
WARNING
Prepare for the flow of fluid, and protect the surrounding
components.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (
Rear brake calliper: Removal - Refitting
Note:
The callipers supplied as replacement parts are
pre-filled.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
WARNING
Pre
Rear brake calliper mounting: Removal - Refitting
DISC BRAKE
REMOVAL
I - REMOVAL PREPARATION OPERATION
Put the vehicle on a two-post lift (see Vehicle: Towing and lifting).
Remove:
the rear wheels (see 35A, Wheels and tyres,
Wheel: Removal -
SEE MORE:
K9K, and 766 or 768
IMPORTANT
Wear protective gloves during the operation.
WARNING
Never rotate the engine anti-clockwise (timing end).
WARNING
Do not run the engine without the accessories belt
so as not to damage the crankshaft accessories
pulley.
I - PARTS TO BE SYSTEMATICALLY REPLACED
the timing belt,
the timin
Rear screen wash/wipe
Speed-dependent
timed rear screen
wiper
With the ignition on, turn the end of
stalk 1 to align mark 2 with the symbol.
Wiping frequency varies with speed.
When working in the engine
compartment, ensure that
the windscreen wiper stalk
is in the park position.
Risk of i
© 2016-2025 Copyright Renault Clio Owners Club
