Renault Clio: Cabin filter: Removal - Refitting

LEFT-HAND DRIVE

Note: The cabin filter is located in the passenger side A-pillar.

REMOVAL

I - REMOVAL PREPARATION OPERATION

SCHOOL VEHICLE

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Cabin filter: Removal - Refitting

Note: Foreign bodies (leaves, insects etc.) are likely to accumulate in the cabin filter. Remove the cabin filter with care so as to prevent foreign bodies getting into the evaporator.

REFITTING

I - REFITTING PREPARATION OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

III - FINAL OPERATION

SCHOOL VEHICLE

RIGHT-HAND DRIVE

REMOVAL

OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Cabin filter: Removal - Refitting

Note: Foreign bodies (leaves, insects etc.) are likely to accumulate in the passenger compartment filter.

Remove the filter with care so as to prevent foreign bodies getting into the evaporator.

REFITTING

I - REFITTING PREPARATION OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

Renault Clio. Cabin filter: Removal - Refitting

READ NEXT:

 Rear air distribution duct: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Lock the airbag computer using the Diagnostic tool (see Fault finding - Replacement of components) (MR 394, 88C, Airbags and pretensioners). Disconnect

 Recirculation control cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Partially remove seal (1). Remove the side panel (2). Remove the bolt (3) from the base

 Air distribution cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the glovebox (see Glovebox: Removal - Refitting) (MR 393, 57A, Interior equipment),

SEE MORE:

 Five door and estate versions

Reversing lights and rear fog lights 12 Open the boot lid. Unclip cover 13 and remove it. Turn bulb holder 14 fully anticlockwise and change the bulb. To reassemble, proceed in the reverse order to removal. When the bulb has been changed, make sure you refit the cover 13 cor

 Suspended engine mounting: Tightening torque

D4F Tightening torque (in Nm) K4J, and JH3 K4M, and JH3 K4M, and DP0 K9K, and JR5 K9K, and JH3 K9K, and TL4 D4F, and JH3 M4R, and DP0 F4R M4R, and TL4

© 2016-2025 Copyright Renault Clio Owners Club