Renault Clio: Navigation: List and location of components
NAVIGATION AID 1 LEVEL or NAVIGATION AID 1
I - LIST OF COMPONENTS
The "navigation" equipment consists of:
- a navigation aerial (see 86A, Radio, Radio aerial:
Removal - Refitting, 86A-11)
NAVIGATION AID 1
- a radionavigation system (see 83C, On-board
telematics system, Radio navigation: Removal -
Refitting, 83C-3)
- a navigation screen (see 86A, Radio, Display: Removal
- Refitting, 86A-18)
NAVIGATION AID 1 LEVEL
- a "computer - navigation screen" assembly (see 83C,
On-board telematics system, Navigation computer:
Removal - Refitting, 83C-4)
- a multimedia network interface unit (see 83C, On-board
telematics system, Multimedia network interface
unit: Removal - Refitting, 83C-7)
- a remote control and its support on the centre
console
II - LOCATION OF COMPONENTS
Navigation aerial

NAVIGATION AID 1
Radio navigation system

Navigation screen

NAVIGATION AID 1 LEVEL
"Computer - navigation screen" assembly

Multimedia network interface unit

Radio navigation: Removal - Refitting
NAVIGATION AID 1

REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the radio navigation system using tool (Ms.1544).
- Disconnect the radio navigation system connectors.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Connect the radio navigation system connectors.
- Refit the radio navigation system.
II - FINAL OPERATION
- Carry out the necessary operations (see MR 394
Fault finding, 83C, Navigation, Replacement of
components).
READ NEXT:
NAVIGATION AID 1 LEVEL
REMOVAL
I - REMOVAL PREPARATION OPERATION
If the "computer - navigation screen" is being replaced,
carry out the necessary operations using the
Diagnostic tool (see Fault f
NAVIGATION AID 1 LEVEL
REMOVAL
I - REMOVAL PREPARATION OPERATION
When replacing the multimedia network interface
unit, carry out the necessary operations using the
Diagnostic tool (see Fault find
Cruise control - speed limiter: List and location of components
CRUISE CONTROL
I - LIST OF COMPONENTS
Switch
Steering wheel switch
Brake switch
Clutch switch
II - LOCATION OF COMPONENTS
1 - Swit
SEE MORE:
D4F, and 740
WARNING
Do not use any product designed to improve electrical
contact in the injection computer connectors
and oxygen sensors and on the oxygen sensor
body. Failure to respect this advice prevents the
oxygen sensor from operating correctly and results
in failure to comply with the emis
M4R
The engine and gearbox assembly must be removed
to remove/refit the camshaft dephaser (see
10A, Engine and cylinder block assembly, Engine
- gearbox assembly: Removal - Refitting, 10A-112).
For the camshaft dephaser removal-refitting procedure
(see ) (Technical Note 6020A, 10A, Engine and
© 2016-2025 Copyright Renault Clio Owners Club
