Renault Clio: Scuttle panel grille: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the wiper arms (see Windscreen wiper
arm: Removal - Refitting) (MR 392, Mechanical
systems, 85A, Washing - Wiping).

II - OPERATION FOR REMOVAL OF PART
CONCERNED


- Remove the scuttle panel grille (3) and (4).
REFITTING
I - REFITTING PREPARATION OPERATION
Note:
Check that the windscreen and the scuttle panel
grille are clean before refitting.
II - REFITTING OPERATION FOR PART
CONCERNED

- Refit:
- the scuttle panel grille,
- the clips (5).
III - FINAL OPERATION.

- Refit:
- the seal (6),
- the wiper arms (see Windscreen wiper arm: Removal
- Refitting) (MR 392, Mechanical systems,
85A, Washing - Wiping).
READ NEXT:
K85
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Remove:
the blanking covers (1),
the nuts (2).
Unclip the tailgate spoiler at (3).
Disconnect:
the high level brake light connecto
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the scuttle panel grille (see 56A, Exterior
equipment, Scuttle panel grille: Removal - Refitting, 56A-1).
Remove the trim under the scuttle pane
REMOVAL
I - REMOVAL PREPARATION OPERATION
Unclip the trim (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove:
the sealing foam (2),
the bolts (3)
the door mirror.
Disconnect th
SEE MORE:
DP0
Do not drain or remove the automatic gearbox in order
to remove the speed sensor.
The output speed sensor has been deleted and replaced
with wheel speed sensors.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A,
Courtesy light
Unclip the lens 1 (using a flat-bladed
screwdriver or similar).
Remove the bulb concerned.
Bulb type: W5W.
Luggage compartment light
Unclip the light 2 by pressing the tab on
its left side (using a flat-bladed screwdriver
or similar).
Remove the bulb concerned.
© 2016-2025 Copyright Renault Clio Owners Club
