Renault Clio: Cabin filter: Removal - Refitting

LEFT-HAND DRIVE

Note: The cabin filter is located in the passenger side A-pillar.

REMOVAL

I - REMOVAL PREPARATION OPERATION

SCHOOL VEHICLE

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Cabin filter: Removal - Refitting

Note: Foreign bodies (leaves, insects etc.) are likely to accumulate in the cabin filter. Remove the cabin filter with care so as to prevent foreign bodies getting into the evaporator.

REFITTING

I - REFITTING PREPARATION OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

III - FINAL OPERATION

SCHOOL VEHICLE

RIGHT-HAND DRIVE

REMOVAL

OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Cabin filter: Removal - Refitting

Note: Foreign bodies (leaves, insects etc.) are likely to accumulate in the passenger compartment filter.

Remove the filter with care so as to prevent foreign bodies getting into the evaporator.

REFITTING

I - REFITTING PREPARATION OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

Renault Clio. Cabin filter: Removal - Refitting

READ NEXT:

 Rear air distribution duct: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Lock the airbag computer using the Diagnostic tool (see Fault finding - Replacement of components) (MR 394, 88C, Airbags and pretensioners). Disconnect

 Recirculation control cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Partially remove seal (1). Remove the side panel (2). Remove the bolt (3) from the base

 Air distribution cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the glovebox (see Glovebox: Removal - Refitting) (MR 393, 57A, Interior equipment),

SEE MORE:

 K4J or K4M

IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5). WARNING To prevent damage to the wiring harness when refitting, observe the original routing. REMOVAL I - REMOVAL PR

 Clutch thrust bearing: Removal - Refitting

The thrust bearing is connected to the clutch slave cylinder. REMOVAL I - REMOVAL PREPARATION OPERATION Drain the brake reservoir using a syringe to remove the clutch thrust bearing and control. Remove the gearbox (see 21A, Manual gearbox, Manual gearbox: Removal - Refitting, 21A- 12). II - R

© 2016-2025 Copyright Renault Clio Owners Club