Renault Clio: Right-hand drive
Renault Clio IV (2014-2019) Owners Manual / Getting to know your vehicle / Driving position / Right-hand drive
The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY.
- Side air vent.
- Passenger Airbag location.
- Heating or air conditioning controls.
- Multimedia touch-screen.
- Windscreen demister outlet.
- Hazard warning lights switch.
- Door electric locking switch.
- Centre air vents.
- Stalk:
- direction indicator lights;
- exterior lights;
- front fog lights;
- rear fog lights.
- Instrument panel.
- Driver Airbag and horn location.
- Multimedia system voice control button.
- Stalk:
- windscreen and rear screen wash/wipe;
- trip computer and warning system information readout.
- Side air vent.
- Controls for:
- electric headlight beam adjustment,
- instrument panel lighting dimmer,
- activate/deactivate the parking distance control system,
- activation/deactivation of the Stop and Start function.
- Cruise control/speed limiter controls.
- Control for adjusting steering wheel height and reach.
- Cruise control/speed limiter main control.
- Activation/deactivation control for ECO mode.
- Handbrake.
- Gear lever.
- Cigarette lighter/accessories socket.
- RENAULT card reader.
- Engine start/stop button.
- Storage space.
- Glovebox.
- Bonnet release control.
READ NEXT:
Warning lights
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT
AND COUNTRY.
Instrument panel A: lights up when
the ignition is switched on. The brightness
can be adjusted by turning
Displays and indicators
Rev counter 1
(graduations x 1000)
Speedometer 2
(km or miles per hour)
Overspeed buzzer
Depending on the vehicle, a buzzer
sounds for approximately 10 seconds
every 40 seconds, as long
On-board computer: general information
On-board computer 1
Depending on the vehicle, this includes
the following functions:
distance travelled;
journey settings;
information messages;
operating fault messages (connected
t
SEE MORE:
Engine stand: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check
Particle filter temperature sensors: Removal -
Refitting
K9K, and 772
The particle filter must be removed in order to remove
the catalytic converter upstream temperature sensor.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02, Lifting equipment).
Disconnect the battery (s
© 2016-2025 Copyright Renault Clio Owners Club
