Renault Clio: Rear parcel shelf side trim: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
C85
- Remove the rear wing panel trim (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32).
B85
- Unclip the rear inner sill upper trim (see 71A, Body
internal trim, Rear inner sill upper trim: Removal
- Refitting, 71A-24).
B85 or C85
- Remove the rear quarter panel trim (see 71A, Body
internal trim, Quarter panel trim: Removal - Refitting, 71A-27).
K85

- Partially remove the seals from the rear side door
and the tailgate.
- Unclip the rear inner sill upper trim at (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
B85 or C85

- Using a flat-blade screwdriver, unclip (2) the rear
parcel shelf side trim.
K85


- Unclip the rear parcel shelf side trim.
- Disconnect the luggage compartment light connector.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
B85 or C85
- Clip the rear parcel shelf side trim onto the rear quarter
panel trim.
K85
- Clip on the rear parcel shelf side trim.
- Refit the bolt (3).
II - FINAL OPERATION.
B85 or C85
- Refit the rear quarter panel trim (see 71A, Body internal
trim, Quarter panel trim: Removal - Refitting, 71A-27).
C85
- Clip on the rear wing panel trim (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32).
B85
- Refit the rear inner sill upper trim (see 71A, Body internal
trim, Rear inner sill upper trim: Removal -
Refitting, 71A-24).
K85
- Connect the luggage compartment light connector.
- Clip on the rear inner sill upper trim.
- Refit the seals on the rear side door and the tailgate.
READ NEXT:
REMOVAL
I - REMOVAL PREPARATION OPERATION
B85 or C85 or S85
Remove the luggage compartment carpet.
K85
Remove the luggage compartment raised floor (1).
Remove the luggage compartment carpe
S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear parcel shelf,
the centre rear parcel shelf (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the clips (2).
Remove
SEE MORE:
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair (see 30A, General information, Brake circuit:
Precautions for the repair, 30A-2).
This procedure must be applied after one of the followin
Remove the wheel trim using hubcap
tool 1 (located in the tool kit) by engaging
the hook in the opening near
valve 2.
To refit it, align it with valve 2. Push the
retaining hooks in fully, starting with
side A near the valve, followed by B
and C, finishing at D opposite the valve.
© 2016-2025 Copyright Renault Clio Owners Club
