Renault Clio: Steering wheel/Power-assisted steering

Adjusting the steering wheel height and depth

Renault Clio. Adjusting the steering wheel height and depth


Pull lever 1 and place the steering wheel in the required position; push the lever beyond the point of resistance to lock the steering wheel in place.

Make sure that the steering wheel is correctly locked.

For safety reasons, only adjust the steering wheel when the vehicle is stationary.

Power Assisted Steering

Never drive with an inadequately charged battery.

Variable power assisted steering

The variable power assisted steering system is equipped with an electronic control system which alters the level of assistance to suit the vehicle speed.

Steering is made easier during parking manoeuvres (for added comfort) whilst the force needed to steer increases progressively as the speed rises (for enhanced safety at high speeds).

Never leave the steering wheel at full lock while stationary.

With the engine switched off, or if there is a system fault, it is still possible to turn the steering wheel. The force required will be greater.

Never switch off the ignition when travelling downhill, and avoid doing so in normal driving (assistance is not provided).

READ NEXT:

 Driving position

 Left-hand drive

The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY. Side air vent. Stalk for: direction indicator lights; exterior lights; front fog lights; rear fog light

 Right-hand drive

The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY. Side air vent. Passenger Airbag location. Heating or air conditioning controls. Multimedia touch-screen. Wind

SEE MORE:

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid valve connector (2), Fit the hose end piece (Mot. 1592) in place of one of the removed plugs.

 Front right-hand driveshaft gaiter, gearbox side: Removal - Refitting

DP0 or JH3 or JR5 or TL4 Deflector Propeller shaft Driveshaft yoke sleeve Spider RC gaiter Tightening clip Lock ring Tightening ring REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Di

© 2016-2025 Copyright Renault Clio Owners Club